1. HOME

Additional Explanation for MULTI SETTING GEAR

MULTI SETTING GEAR Firmware for PGS LH/XB/XR is different from firmware for PGS CL/CX.

MULTI SETTING GEAR can set all compatible device by switching MULTI SETTING GEAR firmware.

Please check and change to MULTI SETTING GEAR firmware same as device firmware.

Default firmware in MULTI SETTING GEAR is for PGS-LH/XB/XR. 

When changing MULTI SETTING GEAR firmware, please follow the steps in the below.



【Firmware Setting Steps】

1.  Download each firmware in the below link

 PGS01003.zip (Firmware for PGS- LH/LH Type-D/XB/XR)

● PGSC1001.zip (Firmware for PGS- CL/CX) 

 

2. Unzip the download folder and save program to Micro SDHC Card


3. Insert Micro SDHC Card to MULTI SETTING GEAR


4. Turn on MULTI SETTING GEAR holding with BACK button


5. Choose correct firmware for your servo and press ENTER button


6. Turn off the MULTI SETTING GEAR


7. After connected your servo, turn on the MULTI SETTING GEAR again. 


8. Start setting 

※If the firmware is not correct. display "PLEASE CHANGE."

Please back to 5. and choose correct firmware. 


Also, we upload Firmware change manual with picture. 

Please check manual in the below.

MULTI SETTING GEAR FIRMWARE CHANGE MUNUAL.pdf

page up